Back To Back Sinks Clog

To use a drain snake remove the sink strainer and insert the tip of the augur down the pipe and twist the hand crank which releases the wire cable.

Back to back sinks clog.

The pressure of the vacuum should dislodge the clog. Then pour the entire kettle of water into the sink and wait. The one that is shaped. Place a bucket beneath your p trap.

This is the vertical pipe that goes up to your sink basin. Snake from the lavatory roof vent and or. Remove the p trap with a screwdriver or wrench depending on the fastener type used on your model. 2 air guns only work when the clog s between the air gun and the vent.

Otherwise all that air simply goes up the vent for back to back lavs there are only two ways to remover a blockage. How can i solve this. Keep feeding more of the snake into the drain. If the water stands in the sink and the clog doesn t move give the water time to cool and remove it to try again.

When you open the cabinet that is below your sink you will see some pipes. If the clog is on one side of a double sink seal up the opposite side of the sink with a rubber stopper. This option is free so you can give this one a go first in order for you not to spend any money. While you re waiting for the water to heat remove as much standing water from the sink as you can using a mug or small pot to bail out the water.

Because the clog will be found below and downstream from the cross and. Place the hose end at the entrance of the drain then create a tight seal around the end of the hose and the drain.